Industrial Electrical Engineering Belfast & Northern Ireland
BSH Limited delivers industrial electrical engineering including electrical industrial power supplies HV & LV, integrated with on-site generation within combination fuelled plantrooms.
Industrial Electrical Engineering Belfast reflects BSH Limited's electrical engineering capability for industrial buildings. BSH's consultancy specialisms explicitly include electrical industrial power supplies HV & LV, alongside natural gas and hydrogen transportation designs and the company's combination fuelled systems work.
Industrial electrical engineering covers high-voltage and low-voltage distribution, switchgear, protection and the connection of on-site generation — combined heat and power, fuel cells or other prime movers — into the site's electrical infrastructure. Because BSH designs combination fuelled systems that include heating, cooling, combined heat and power, domestic and control systems, the electrical and thermal sides of an industrial project are specified together.
Where on-site generation is present, the electrical system must carry the electricity output while the thermal system uses the recovered heat — which is where industrial electrical engineering meets the combination fuelled plant. BSH's work on hydrogen-to-power and its listed HV and LV specialisms reflect that integration.
HV and LV industrial power supplies
BSH's consultancy specialisms include electrical industrial power supplies HV & LV. An industrial electrical system covers the high-voltage and low-voltage distribution, switchgear, protection and metering that supply an industrial site, with the HV/LV infrastructure specified against the site's loads, any on-site generation and the wider combination fuelled system.
Integrating on-site generation
Where combined heat and power or other on-site generation is present, the electrical system carries the electricity output and the thermal system uses the recovered heat. Because BSH designs combination fuelled systems that include heating, cooling, CHP, domestic and control systems, the electrical integration and the thermal integration are designed together rather than as separate disciplines.
Power and heat as one system
Efficient industrial electrical engineering treats the electricity and the recovered heat as opposite outputs of the same generation: the power system distributes the electricity while the thermal system uses the heat for heating, domestic hot water or, through absorption chilling, cooling. BSH designed and built the largest trigeneration plant room in Europe in 2012, which integrated generation, power and thermal recovery.
Commercial applications
Where this service applies
- Industrial sites needing HV and LV power distribution
- Facilities integrating on-site combined heat and power
- Sites pairing electrical systems with hydrogen-to-power generation
- Developments delivered through integrated plantrooms
Benefits & considerations
What to consider
- HV and LV power supplies among BSH's consultancy specialisms
- On-site generation integrated with the thermal system
- Power and heat designed as one combination fuelled system
- Over 50 years of engineering expertise across three generations
Problem · Reaction · Solution
How BSH can help
Problem
Industrial electrical engineering carried out in isolation from the on-site generation and the thermal loads it serves can end up with generation sized for electricity alone, recovered heat with no load to use it, and HV/LV distribution that does not match the way the site actually consumes power. Where the electrical and thermal sides are procured separately, the integration that makes on-site generation worthwhile is lost at the interface between them.
Reaction
Uncoordinated industrial electrical design raises cost, wastes recoverable heat and can create protection and stability issues where on-site generation is not properly integrated with the site's distribution. Industrial operators, consultants and contractors need an engineering partner who designs the electrical system alongside the generation and the thermal loads as one combination fuelled system.
Solution
BSH delivers industrial electrical engineering including electrical industrial power supplies HV & LV, integrated with on-site generation within combination fuelled plantrooms. Because the right electrical arrangement depends on your loads and generation, the next step is to discuss your requirements with BSH's engineers. Contact BSH to discuss your industrial electrical engineering project.
Questions & answers
Common commercial questions
Discuss your industrial electrical engineering project
Talk to BSH about HV and LV power supplies and on-site generation integrated within a combination fuelled plantroom.
Contact us