Commercial Electrical Engineering Belfast & Northern Ireland
BSH Limited engineers commercial electrical systems — HV and LV power supplies, switchgear, controls and on-site generation — integrated with the mechanical plant it powers through combination fuelled plantrooms.
Commercial Electrical Engineering Belfast reflects BSH Limited's electrical engineering across commercial and industrial buildings. BSH's core strengths rest in the engineering disciplines — electrical, plumbing and heating systems — bringing together experience spanning over 50 years from three generations, and electrical industrial power supplies HV & LV are among the listed consultancy specialisms.
Commercial electrical engineering covers the HV and LV power supplies, switchgear, protection, metering, controls and any on-site generation that power a building's services. Because BSH designs combination fuelled systems that include heating, cooling, combined heat and power, domestic and control systems, the electrical engineering is specified with the mechanical plant it powers rather than as a standalone electrical scope.
Where the electrical and mechanical plant are delivered through a pre-packaged plantroom, the electrical systems and controls are assembled and inspected off site before delivery, keeping the power and control integrated with the mechanical services from the outset.
HV and LV power with the mechanical plant
Electrical industrial power supplies HV & LV are among BSH's listed consultancy specialisms, so the high-voltage and low-voltage distribution, switchgear, protection and metering are part of the same scope as the mechanical plant they feed. That keeps the electrical installation consistent with the mechanical services it powers, and avoids the integration gaps that arise when the electrical and mechanical scopes are split across contractors.
Controls and on-site generation
Commercial electrical engineering also covers the control systems that sequence the plant against real loads and the electrical side of any on-site generation. Where combined heat and power or other on-site generation is present, the electrical engineering carries the electricity output while the thermal system uses the recovered heat, and installing both as one combination fuelled system keeps the generation matched to the building's electrical and heat loads.
Delivered through plantrooms
Where the plant is delivered through a pre-packaged plantroom, the electrical systems and controls are assembled and inspected off site before delivery as a plug and power solution. That keeps the power and control integrated with the mechanical services and supports rapid commissioning once on site, with the on-site access independent from the main building.
Commercial applications
Where this service applies
- Commercial and industrial buildings needing coordinated electrical engineering
- Sites with on-site generation needing electrical and mechanical in one scope
- Plantrooms combining HV and LV power with heating and cooling
- Projects needing controls and power installed with the mechanical plant
Benefits & considerations
What to consider
- HV and LV power supplies within the same engineering scope
- Controls and on-site generation integrated with the mechanical plant
- Plantroom delivery for rapid, low-disruption installation
- Over 50 years of engineering expertise across three generations
Problem · Reaction · Solution
How BSH can help
Problem
Splitting electrical engineering from the mechanical scope creates integration gaps at the interfaces between power, control and equipment, and leaves the control system to be retrofitted after the mechanical plant is installed. Where the electrical is procured separately from the mechanical, the coordination that makes an integrated system workable is lost, and the plant ends up powered and controlled by a system that was never designed with it.
Reaction
Split electrical scopes raise cost, integration risk and running cost, and make a building harder to commission and manage. Building owners, contractors and consultants need an engineering partner who engineers the electrical and mechanical plant as one combination fuelled system rather than across separate contractors.
Solution
BSH engineers commercial electrical systems — HV and LV power, switchgear, controls and on-site generation — integrated with the mechanical plant it powers, often through combination fuelled plantrooms. Because the right electrical scope depends on your plant, the next step is to discuss your requirements with BSH's engineers. Contact BSH to discuss your commercial electrical engineering project.
Questions & answers
Common commercial questions
Discuss your commercial electrical engineering
Talk to BSH about HV and LV power, switchgear, controls and on-site generation integrated with your mechanical plant through a pre-packaged plantroom.
Contact us